12V 150AH LiFePO4 Lithium Iron Phosphate Deep Cycle Battery With BMS

Ideal power for Solar Wind RV UPS Audio Marine Kayak.

The TOBattery LiFePO4 Battery Model LFP12150BP is a state of the art 12V 150Ah battery.
Designed primarily for loads requiring 12V voltages to operate.
This battery features a small and compact form factor designed for the smallest footprint.
The battery Is made of 4 pcs 150AH Lithium Iron Phosphate Cells. It has an integrated BMS (Battery Management System) which provides complete internal cell balancing and integrated protection.
Cells and BMS are designed to be solder-free and can be easily removed and installed.

 Built-in BMS, safe and long life
 Compatible with 12V lead-acid battery
 Can use lead acid battery charger

LFP12150BP Battery Specifications

Voltage: 12V
Capacity: 150Ah
Outer packaging: PVC heat-shrinkable film
Charger & Discharge Connector:   150 Amps Cold Crimp Terminals With 8AWG open end wire
Cut-off Discharging voltage: 10V
Rated Discharging Amperage: 150 Amps
Max. Discharging current: 300 Amps @ 10S
Charging Current: <75 Amps
End of Charging Voltage: 14.5 Volts
Dimensions: (L x W x H) 200x175x185mm 
Weight: 27 lbs. 

Built-in full-featured BMS (Battery Management System) which provides internal cell balancing and voltage, current and temperature protection during charging and discharging.

BMS features:

Charge over-voltage protection (3.65V/cell)
Discharge undervoltage protection (2.30V/cell)
Charge overcurrent protection (80A)
Discharge overcurrent and short circuit protection (160A continuous, 320A for 10 seconds, 640A for 0.25mS)
Charging high and low temperature protection (32°F~122°F)
Discharge high and low temperature protection (-4°F~130°F)
MOS high temperature protection (167°F)
Charge balance function (Starting 3.535V, balance current 185mA)
Active dynamic equalization function (turns on active equalization when voltage difference between adjacent cells >0.1V , balance current 1 A)

Caution:

1:The batteries we sell are universal products and may not support some specific loads and chargers.
2:Easy to disassemble BMS, please be very careful when disassembling, the electrodes are very close to each other, please never short circuit.
3: Please keep the battery and BMS absolutely dry
4: BMS should not be used in series with each other
5: BMS will cut off the output when the temperature is too high and too low
6: BMS will cut off the output when the charging and discharging current exceeds the rated value
7: BMS will cut off the output when the voltage is too high and too low
8: BMS will automatically restore the output after the protection condition is lifted, but if the battery is connected to a load, it may be necessary to disconnect the load to resume the discharge.